Easy Assist
|
The Redneck Ram can be ordered in several different lengths. Typically a Dana 30 and some 44s use a six-inch ram, where other Dana 44s and Dana 60s need an eight-inch unit. Our Rockwell axle needed a nine-incher. The length needed can vary so make sure you measure your tie-rod swing before ordering. The rams are available in 1 1/2-inch and 1 3/4-inch bores. The 1 3/4-inch units will provide more power assist but will move slightly slower than the 1 1/2-inch units. We weren't too worried about speed and we had plenty of room, so we went for the 1 3/4-incher. We centered it and tack welded it in place then checked for clearance when turned. Mount the ram as parallel as possible to the tie rod it is being attached to. View Related Article
|
|
|
|